Switch capacity: up to 5 A, higher loads can be switched with relays or.The MSD controls fluorescent lamps and low-voltage halogen lamps with dimmable electronic ballasts or transformers with 1-10 V interface or up to 3 ALTENBURGER load dimmers. Height of 2.5 - 3 m, for extension of the detection area, one master Multi-SensorDimmer can be assigned up to 5 Multi-Sensor-Dimmer in slave mode.ĭaylight dependent constant light control with presence detection and with setting ofĬonstant light value at the MSD or by remote customary pushbutton. Possibility to deactivate presence detection,Įxtension of detection area by combining of up to 6 Multi-Sensor-Dimmers,Īll Multi-Sensor-Dimmers can be combined with all types of ALTENBURGER loadģ60° detection area of the Multi-Sensors with 9 m in diameter at a mounting Switch capacity of 5 A, higher loads can be switched with relays or contactors, Potion falls below the preselected constant light level,
#BECKER TIMECONTROL TC52 MANUAL#
Manual lighting control (with the functions BRIGHTER, DARKER, ON/OFF),ĭaylight dependent constant light control,Īutomatic switch-off of lighting as soon as daylight exceeds the preselectedĬonstant light level or if no presence is detected,Īutomatic switch-on of lighting as soon as presence is detected or the daylight Main characteristics of all Multi-Sensor-Dimmers are:ġ-10 V/0-10 V interface for the control of electronic ballasts, transformers or Or transformers with 1-10 V interface or for ALTENBURGER load dimmers.įor non-dimmable lamps Multi-Sensor-Lighting Value Control Switches (MSLRS, see page 8) or Multi-Switches (MS, see page 9) are applicable. They are suitable for all types of lamps in connection with electronic ballasts Multi-Sensor-Dimmer/Multi-Sensor-SwitchesĬolors and form designs of ceiling recessed housingĪLTENBURGER Multi-Sensor-Controls ensure a maximum possible level on reliability, energy conversation and comfort in lighting automation. KSV-S Signal amplifier in lighting installation design 19 KMSS Multi-Sensor-Dimmer in lighting installation design Multi-Sensor-Controls for installation in luminaries Lux-Value Transducer for building management systems, suitable for up to three lighting circuits 16 Multi-Sensor-Controller for the EIB/KNX-Bus 11ĭaylight dependent operating 3-channel Light Value Control Switch for the EIB/KNX-Bus 12ĭCBNV DALI-Controller Basic, Multi-Sensor-Dimmer in connection with DALI-Controls 13ĭC NV Multi-Sensor-Control with DALI-Dim/Converter Controlĭaylight dependent operating dimmers and switchesĬonstant-Light-Controller LWS1 Light-Value-Control-Switch, suitable for one lighting circuit LWS3 Light-Value-Control-Switch, suitable for up to three lighting circuits LM 3 Multi-Sensors for EIB/KNX-Lighting Controls Multi-Sensor-Dimmer for DIN-rail mounting and for connection of up to 6 Multi-Sensors Multi-Sensor-Dimmer with IR-control for programming and selection of lighting scenes and light values MSL Multi-Sensor-Dimmer with minimum/maximum limitation 6 MSD-T Multi-Sensor-Dimmer with external adjustment of set-point and manual lighting control with pushbutton Multi-Sensor-Lighting Controls for Lighting AutomationĬolors and form designs of ceiling recessed housings 3